Thanks for the pictures! To replace the converter section of your WF-8955PEC 55A power center, I recommend the Progressive Dynamics Replacement Converter for WFCO RV Power Centers item # PD4655V. This unit will fit in the same dimensions that your WF-8955PEC fit in and only replaces the converter section view full answer...
I spoke with my contact at Convert-A-Ball about the pin weight capacity of their CG Cushioned Gooseneck Coupler. They list a 30,000 lb weight capacity for the coupler and a 4,000 lbs tongue, or pin weight.
Since your 2400 lb pin weight isn't even 10 percent of the 30K coupler capacity, the coupler should handle it just fine. view full answer...
The Progressive Dynamics RV Converter part # PD9160ALV would easily be able to charge two 100 ah lithium batteries. As long as you have a thick gauge wire for the batteries from your old setup this would work fine since you'd be going from a 45 amp to 60 amp setup. view full answer...
The Go Power RV Converter and Smart Battery Charger - 12V - 100 Amp # 34266912 is capable of putting out up to 100 amps so the amperage of your stove that you mentioned would easily work with that. view full answer...
The replacement for a WFCO WF-9865-AD-CB converter is the Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger item # PD9270. This converter charger has an amperage output of 70 amps and a rated power output of 950 watts. It uses the Charge Wizard multistage charging system to charge your battery bank and works with flooded lead acid, AGM, and gel batteries. view full answer...
No, you won't. The Progressive Dynamics 4100 Series RV Converter w/ Charge Wizard and AC/DC Distribution Panel item # PD4135K will replace your converter and everything else. This 2-in-1 unit combines an AC/DC distribution panel with a smart converter charger that works with lithium-ion, LiFePO4, flooded lead acid, AGM, and gel batteries.
I have linked an installation video below so you can see how this panel gets set up. view full answer...
The Replacement Converter for Parallax/Magnetek Power Centers item # PD4645V you were looking at is the most direct replacement for the Magnetek 6300 series at 45 amps. It will work with flooded lead acid, AGM, gel batteries, and is made in the USA. view full answer...
You are correct the 6332 model Magnetek converter is not compatible with Lithium batteries. To upgrade to a lithium battery system you will need to replace the entire power center with the Progressive Dynamics RV Power Control Center item # PD4135K. This unit has up to 4 branch circuits and 7 DC fuse ports to handle all the electrical needs of your RV.
I have linked a help article below that will walk you through setting up a solar powered system that will suit your specific needs. I recommend... view full answer...
I have attached a few photos for you with all the dimensions we have for the Ark Drop Down Corner RV Stabilizer Jacks part # AR34FR. That said, Ark is an Australian company so the measurements are in metric, millimeter to be specific so you may need to do some converting. In order to convert from millimeter to inch, divide by 25.4. For example, 422mm is roughly 16-1/2". view full answer...
Thanks for the picture! The Replacement Converter Section item # PD4045CSV is the correct part you need to replace your PD4045KA converter. It is compatible with Lithium batteries you'll just have to flip the LI/LA switch.
I linked the instructions below so you can verify but it does charge up to 14.6 +/-.3VDC for Lithium batteries. view full answer...
There's not an option to upgrade just the converter on your power center if you are wanting to use lithium batteries. I say this because most people who upgrade their converters on the Magnetec series 6300 do so to change over to lithium batteries.
The best option is the only option and that is to replace your entire power center with the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger item # PD4135K. This 2-in-1 AC/DC distribution panel and converter... view full answer...
Yes, you can charge two 12v batteries when they are connected in parallel using the Go Power RV Converter and Smart Battery Charger item # 34266167. 35 amps are more then enough to charge your batteries in parallel. However, it will take longer to charge the batteries when they are connected compared to if you were to charge each one separately. view full answer...
The depth of the RV Tub part # LC209678 you referenced is 10-1/2 inches. I attached a dimension picture for a similar color tub for you to check out as well. view full answer...
The mounting holes on the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers # PD4655V are 12-1/2" X 2-3/4" on center(see image). This will fit your Parallax 7355 power center. view full answer...
Yes, the WeatherTech All-Weather Front Floor Mats # WTW51TN will fit your Four Wynns RV. These mats are a fit for a 2010 Ford E-450, which is the chassis your Four Wynns RV was built on. I also highly recommend using the Cleaner and Protector Kit for WeatherTech Floor Mats # WT8LTC36K if you use your RV with any regularity to keep your mats clean and prolong their life. You can take a look at a video review I've linked for you on this product as well. view full answer...
The Mighty Cord RV Power Adapter Y-Cord # A10-50X30Y that you referenced is designed for 240 volt applications it will not convert amperage. To go from two 30 amp sources to a single 50 amp. view full answer...
The Converter for Parallax/Magnetek or WFCO RV Power Centers # PD4645V is rated for 45 amps of 12 volt power with up to 610 watts of output power. This is roughly the same amount of input wattage or about 5.1 amps of 120 volt power at maximum draw. Since the power from the converter is mostly used for charging the 12 volt battery and supplying power to the 12 volt lights, slide motors, power awning, and any other 12 volt components on your trailer it will often only be pulling much less... view full answer...
The diameter of the end cap of the Solera 12V Power RV Awning Conversion Kit - Black # LC434723 as well as White # LC434724 is 3-5/8 inches in diameter.
I have added links to video reviews for you to check out as well. view full answer...
The Power Grip Generator Adapter for RV Power Cord # CAM55422 referenced in your question features an overall length, from end to end, of 14 inches.
This is a really nice 125-Volt adapter that will allow you to convert your RV's 50-amp power plug to work with a 30-amp twist-lock outlet on a generator. I have attached a short video demonstration on this product that you can also check out. view full answer...